Problem
You have misplaced the password for your ICX device.
Solution
Perform the following to reset the password
-
Start a CLI session over the serial interface to the Brocade device.
-
Reboot the device.
-
While the system is booting, before the initial system prompt appears, enter b to enter the boot monitor mode.
-
Enter no password. (You cannot abbreviate this command.)
-
Enter boot. This command causes the device to bypass the system password check.
-
After the console prompt reappears, enable the prompt and assign a new password.
Tested Platforms
Brocade ICX 7450 48P
Reference
http://www.brocade.com/content/html/en/hardware-installation-guide/FI_08030_ICX64XX/GUID-7E5B88D3-5E22-41E8-B603-AFB0E312BCDA.html
Hits: 441